Použití
Zur Erhöhung der Aushärtegeschwindigkeit von Sekundenklebstoffen.
Wenn die Aushärtung durch Faktoren, wie z.B. zu großer Klebspalt, poröse oder saure Oberfläche verzögert oder gestört wird, ist der Einsatz des Aktivators ergo® 5100 empfehlenswert.
Der Aktivator wird dann auf die poröse bzw. inaktivere Oberfläche auftragen. Nach Ablüftung des Lösungsmittels kann der Klebstoff auf das 2. Bauteil aufgetragen werden.

Provedení

• Accelerates the hardening process
• Use of the activator is recommended especially for unfavourable porous, inactive (acidic), non-polar surfaces or large bonding gaps
• In this case, the product is applied on one side (to the porous, inactive surface) before bonding
• ergo. cyanoacrylate adhesives are cyanoacrylic acid ester-based one-component products that harden under the influence of humidity
• ergo. cyanoacrylates are mainly used for bonding plastics, elastomers and metals
• The main advantages of these modern adhesives are the curing speed, ease of application and good mechanical strength of the bonds
• In principle, ergo. cyanoacrylate adhesives can be used in a temperature range from -55 °C to +120 °C (depending on the type)
• Activator ergo® 5100 is applied at least 2 minutes prior to the adhesive, usually to one side, and must be completely dry before the parts are joined. It takes 60-120 seconds to dry

Poznámky
Cyanoacrylate vapours can irritate the mucous membranes and eyes. It is therefore advisable to ensure good ventilation/extraction at the workplace and to wear protective gloves (not cotton) and safety goggles. Cyanoacrylate glues skin and eyelids together within seconds. Keep out of the reach of children. Please contact us if you would like the corresponding safety data sheet and technical data sheet. Please observe the additional information on the containers.