Wire cup brush dia. 50 mm, shank 6 mm, grain 180, blue universal

Použití
Universal application for cleaning, derusting and smoothing, and for removing corrosion and paint. Particularly suitable for brushing work on large, flat and easily accessible surfaces as the brush can be used face-down with the entire brush face applied to the workpiece. Specially developed for use at low speeds on cordless drills and power drills. Brushes with plastic filament are particularly suitable for deburring work and for surface repair.

Provedení

• Machinable materials: Aluminium, bronze, stainless steel (INOX), highly heat-resistant materials, cobalt-based alloys, hard non-ferrous metals, other non-ferrous metals
• End no. 301
  Machinable materials: Nickel-based alloys (e.g. Inconell and Hasteloy), nickel- or titanium-based superalloys, titanium, titanium alloys, soft titanium alloys (tensile strength 500 N/mm²)
• End no. 302
  Machinable materials: Thermosets, cast iron, wood, steel, cast steel, thermoplastics
• Machining tasks: Roughing, deburring, cleaning
• End no. 301
  Machining tasks: Removing discolouration, stripping paint, derusting, removing oxide layers
• End no. 302
  Machining tasks: Texturing (matting, matt-finishing and burnishing)
• Drive type: Drill
• The plastic filament can withstand temperatures of up to 220 °C

Výhoda

• Extremely flexible for optimal adaptation to the contour of the workpieces
• Abrasive grains are embedded in flexible plastic filaments, which means that the filament can work on the sides as well as the tip

Poznámky
Recommendations for use: Please observe the recommended speed values. For the best performance, use a tool drive with at least 300 W. Use coolant for applications involving high heat development.
Safety precautions: When clamping the brush, make sure that the shank is clamped as far into the mount as possible. This is especially important when using at high speeds. The minimum clamping length is 10 mm.